Dominic,
I have tried the grid system on a 2d elevation and the grid is resymbolized
into the elevation view. It also adds a floor level indicator.
The floor or floors that get indicated is based on which levels cross the
elevation clip volume in the 3d model.
So an inteior room elevation only shows the floor level of the room while
an exterior elevation would show all the floors.
I also noticed the column numbering moves to the extent of the top elevation clip cube
on the single floor elevation.
What started this thread is I was trying to get a similar effect on a detail plan
or enlarged plan view.
The entire grid shows correctly on a full size plan.
But if I have a enlarged plan located at the middle of the building,
only the grid lines show. It would be cool to get the crossing column numbers
showing on the the enlarged plan too.
I also would like to see a settings file specific for architects and the new grid tool
loading when only the architectural icon is used.\
Tom