Forum Post: Help with a line style

I am almost there and just can't quite get it.  I HAVE ATTACHED A PICTURE AND A .RSC FILE.
ANY HELP IS APPRECIATED.

I need a line style that: has 2 parts

1. line that represents rebar left to right sitting on top of
2.Rebar that you cut through.

I create points just fine and the end points and vertex are fine and at an elevation below the line.  So far so good.

I first cannot get the stroke and it's point to work the rebar in between.  12" between each max.  Outside pairs vary'

Second _ cannot get a line above to stop.  I can start it 4"(.2916667) from the left edge but can't the get the right edge the same.